济南微纳颗粒仪器股份有限公司——三十年激光粒度仪厂家,高新技术企业, 颗粒测试领域上市企业。

激光粒度仪的调试前的需要检查五点

来源:

作者:


 激光粒度仪使用时也要进行特定的安装调试,那么我们如何正确的对粒度仪进行正确的调试呢?还有就是在调试时要注意那些问题呢?在正式开始使用激光粒度仪,我们需要做好激光粒度仪的调试前的检查工作。具体工作内容如下:

The use of laser particle sizer are subject to the specific installation and debugging, then how can we correct the sizer correct debugging? There is in commissioning should pay attention to those problems? In the official start using laser particle sizer, we need to do a good job of laser particle sizer commissioning before the inspection work. Specific work is as follows:

  1、新安装的设备,在设备就位时,难免会残留铁块、焊条头、焊渣等异物。在不开主电机的情况下,打开进料口下面的除杂挡板,让杂质和洗仓物料从此处排出;

1, the new equipment installed in the equipment in place, will foreign body iron, welding head and welding slag etc.. When the main motor is not opened, the impurity removing plate is opened under the feed port, so that impurities and washing materials are discharged from this place;

 

  2、当我们前期检查一切正常后,通电启动设备。检查所有电机的旋转方向;

2, when we check all previous normal, electrify start device. Check the direction of rotation of all motors;

 

  3、检查电磁阀喷吹是否正常吸合有力,调节除尘器电磁阀脉宽和喷吹间隔时间;

3, check whether the solenoid valve jet is normal, pull strong, adjust the dust collector solenoid valve pulse width and jet interval time;

 

  4、检查刹克龙下面关风器是否有漏风现象,可以用手或细粉料放在接口处有无往里吸的感觉,如有必须进行密封处理。上述检查一切正常后,准备带料生产;

4, check the cyclone wind closing device if there is leakage phenomenon, can use hand or fine powder on the interface without feeling smoke inside, if must be sealed. The above inspection is normal, ready to take material production;

 

  5、对激光粒度仪www.jnwinner.com的喂料电机和分级轮电机两个变频器进行参数检查设定,检查电机所对应的空开、接触器、热继电器、过电流继电器调整是否合适,将一次线全部重新锁紧一遍。

5 frequency converter of laser particle sizer www.jnwinner.com feeding motor and grading wheel motor parameters corresponding to check the settings, check the motor circuit breaker, contactor, thermal relay, overcurrent relay adjustment is appropriate, will be the first line to lock again.